When I generate report to review...I only see one bedroom. ( for example master bedroom)  When I save report and go back in to do another room. The generate report shows only that room ( for ex. guest room) Im looking for separate pages for each room.

David

I have used the same technique as Dominic stated for a multi-unit building Inspection.
You will have two things happen.  More information to fill out and more time needed to complete your report.   Some HIP users are packing all the rooms / units inspected under one tab and just use the description/location in the sub-category. Your report will increase in size like mine did.  Large reports like mine can be overkill..  90 + pages and hours of work..
Not worth the $ / hour factors..  Grocery store bagger makes more money at some point.   

Patrick,

I was kind of confused by what you're saying too. Mind to elaborate? Obviously there's a few ways to lay things out.

1. You can do it completely system by system like the Texas template where all plumbing is one one section all electrical is in one section etc. Then you point out a problem and where it exists withing that section.

2. You use the default where it's per room but there's one bathroom & one bedroom section. You list the locations for the bathroom & bedroom, i.e. Master #1, Guest Bathroom #2, 1/2 Bath Downstairs #3. Then as you're going through the bathroom tabs you add a comment to black/red then add #1,#2, or #3 (or a combo of those) at the end of the comment. This creates a legend at the top of the page and keeps the page shorter and condensed.

3. You go completely one section per room and go to edit template and click copy for each bathroom and bedroom you have.

I'm sure there's even some other variations out there!